Summary of Contents for Beckhoff CU8880-0000
- Page 1 Installation- and Operating instructions for CU8880-0000 Ethernet Controller with USB Input Version: 1.3 Date: 2009-07-16...
-
Page 3: Table Of Contents
Connecting devices Connecting cables Operating Instructions Configuration Appendix Assembly dimensions Beckhoff Support & Service Beckhoff branches and partner companies Beckhoff Headquarters Beckhoff Support Beckhoff Service Technical data Approvals for USA and Canada FCC: Federal Communications Commission Radio Frequency Interference Statement... -
Page 4: General Instructions
Modifications to hardware or software configurations other than those described in the documentation are not permitted, and nullify the liability of Beckhoff Automation GmbH. Description of safety symbols The following safety symbols are used in this operating manual. They are intended to alert the reader to the associated safety instructions. -
Page 5: Product Description
Product Description Product Description Product Overview View of the CU8880-0000 The CU8880 USB-to-LAN adapter places an additional industrially-suited and independent Ethernet interface at the user’s disposal. In this way, four or more Ethernet interfaces can be implemented, depending on the system configuration. -
Page 6: Power Supply
The connector are 1 USB port Type B and a RJ45-connector. The pins are described below: USB type B Port (X20) (standard-cable) USB type B Port Signal Data - Data + shield shield RJ 45-Port (X10) (standard CAT5-cable) RJ 45 Port Signal n.c. n.c. n.c. n.c. CU8880-0000... -
Page 7: Led Diagnostics
Status Meaning power supply no power supply connected lights green via USB-Port Ethernet port lights green Ethernet Collision Ethernet port lights yellow Ethernet full duplex Ethernet port lights Ethernet Link Ethernet port Ethernet Speed 10MBit lights Ethernet Speed 100MBit CU8880-0000... -
Page 8: Installation Instructions
4. Please keep the associated paperwork. It contains important information for handling the unit. 5. Check the contents for visible shipping damage. 6. If you notice any shipping damage or inconsistencies between the contents and your order, you should notify Beckhoff Service. CU8880-0000... -
Page 9: Mounting / Unmounting
(figure 2): Unmounting the Ethernet To release the CU8880 from the mounting rail pull down the locking clip Controller with a screwdriver (figure 1) and pull off the device from the rail (figure 2): CU8880-0000... -
Page 10: Connecting Devices
• Disconnect all the devices that are to be connected from the power supply. • Connect all the cables between the CU8880 and to the devices that are to be connected. • Reconnect all devices to the power supply. CU8880-0000... -
Page 11: Operating Instructions
Operating Instructions Operating Instructions Configuration Software driver Drivers for the USB-to-LAN adapter are available for Windows XP Professional, and Windows XP Embedded. The provided CD contains the according configuration software. Note CU8880-0000... -
Page 12: Appendix
The product is characterized by small overall installed size. With a height of approx. 100 mm, the module dimensions exactly match those of the Beckhoff Bus Terminals. Together with the lowered connector surfaces, this means that it can be used in a standard terminal box with a height of 120 mm. -
Page 13: Beckhoff Support & Service
Please contact your Beckhoff branch office or partner company for local support and service on Beckhoff products! The contact addresses for your country can be found in the list of Beckhoff branches and partner companies: www.beckhoff.com You will also find further documentation for Beckhoff components there. -
Page 14: Technical Data
FCC: Canadian Notice FCC Approval for Canada This equipment does not exceed the Class A limits for radiated emissions as described in the Radio Interference Regulations of the Canadian Department of Communications. CU8880-0000...