Routine Tire Inflation Pressure Checks; Tire Pressure Warning System Certification - Toyota 2010 Corolla Owner's Manual

4-3. Do-it-yourself maintenance
When the initialization of the tire pressure warning system has
■
failed
Initialization can be completed in a few minutes. However, in the follow-
ing cases, the settings have not been recorded and the system will not
operate properly. If repeated attempts to record tire inflation pressure
settings are unsuccessful, have the vehicle inspected by your Toyota
dealer.
When operating the tire pressure warning reset switch, the tire pres-
●
sure warning light does not flash 3 times.
After carrying out the initialization procedure, the tire pressure warn-
●
ing light blinks for 1 minute then stays on after driving for about 20
minutes.

Routine tire inflation pressure checks

■
The tire pressure warning system does not replace routine tire inflation
pressure checks. Make sure to check tire inflation pressure as part of
your routine of daily vehicle checks.

Tire pressure warning system certification

■
FCC ID: PAXPMV107J
FCC ID: HYQ13BCX
IC ID: 3729A-PMV107J
IC ID: 1551A-13BCX
For vehicles sold in the U.S.A.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC WARNING:
Changes or modifications not expressly approved by the party responsi-
ble for compliance could void the user's authority to operate the equip-
ment.
For vehicles sold in Canada
Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
334