Connection Of The Speaker Cables - Panasonic SB-WA330E Service Manual

5 Connection of the Speaker Cables

TOP PREVIOUS NEXT
Be sure to connect speaker cables before connecting the AC power supply cord.
The load impedance of any speaker used with this unit must be 4Ω.
Be sure to connect the cable from the right speaker to the right terminal and the cable from the
left speaker to the left terminal.
1. Strip off the outer covering, and twist the center conductor. Make sure the bare ends of the
wires are not unravelled. (If they are, twist them tight again.)
2. Insert the wire to the rear panel of the unit and close the lever.
Notes :
To prevent damage to circuitry, never short-circuit positive (+) and negative (-) speaker wires.
Be sure to connect only positive (red) wires to positive (+) terminals and negative (black)
wires to negative (-) terminals.