Replacing Light Bulb; Replacing Head Lamp - Kubota M8540 Narrow Operator's Manual

Fuse Capacity
No. (A)
(1) 10 Horn
(2) 10 Transmission Control
(3) 25 Auxiliary Socket
(4) 15 Work Light (Right)
(5) 15 Work Light (Left)
(6) 5 Alternator, Engine, PTO, Heater
(7) 5 Meter Panel, OPC
(8) 10 Turn Signal
(9) 15 Auxiliary Power
(10) 5 Meter (Back Up)
(11) 20 Head light, Tail Lamp
(12) 15 Flasher (Hazard)
(13) 5 Starter Relay
(14) 40 Key switch, Head light, Hazard
(15) 30 Fuel cut solenoid
(16) 50 Charge, Heater
BReplacing Light Bulb
Light
Head light
Hazard and Turn signal light (rear)
Hazard and Turn signal light (front)
Front position light
Front work light
Brake stop light
Tail light
Number plate light
BReplacing Head Lamp
To avoid personal injury:
A Be careful not to drop the bulb, hit anything
against the lamp, apply excess force, and get
the lamp scratched. If broken, glass may cause
injury. Pay more attention to halogen lamps in
particular, which have high pressure inside.
A Before replacing the lamp, be sure to turn off
the light and wait until the bulb cools down,
otherwise, you may get burned.
1. While pushing the right and left lock buttons, pull and
remove the electrical connector.
2. Remove the rubber boot.
3. Remove the clamping fixture and take out the bulb.
Protected circuit
Capacity
12V, 55 / 60 W (H4)
12V, 21 W
12V, 21 W
12V, 10 W
12V, 21 W
12V, 21 W
12V, 10 W
12V, 10 W
4. Replace with a new bulb and reinstall the head lamp
assembly in the reverse order.
(1) Electrical connector
(2) Lock buttons
(3) Rubber boot
(4) Clamping fixture
(5) Bulb
A Be sure to use a new bulb of the specified wattage.
A Never touch the bulb surface (glass) with bare hands.
Fingerprints, for example, may break the bulb.
PERIODIC SERVICE
(A)"Base's wider projection to face
upward"
75