Kubota M8540 Narrow Operator's Manual page 31

3. Place the shift levers in "NEUTRAL"
position.
(1) Hydraulic-shuttle shift lever
(2) Main gear shift lever
4. Place the PTO clutch control switch in
"OFF" position and hydraulic control
levers in "LOWEST" position.
(1) PTO clutch control switch
(2) Position control lever
(3) Draft control lever
(N) "NEUTRAL POSITION"
"ON" "OFF"
(A) "DOWN"
OPERATING THE ENGINE
5. Set the throttle lever to about 1/2 way.
(1) Hand throttle lever
(2) Foot throttle
6. Insert the key into the key switch and
turn it "ON".
"OFF" (Engine-Stop)
"ON" (Engine-Run)
C Check Easy Checker(TM) Lamps:
1. When the key is turned "ON", lamps (2) (3) (5) should
come on. If trouble should occur at any location while
the engine is running,
corresponding to that location comes on.
2. Suppose that the engine coolant temperature is not
high enough yet. The heater indicator (4) also comes
on when the key is turned "ON" to preheat the engine
and goes off automatically when preheat is completed.
Illumination time of indicator varies according to the
temperature of coolant
3. The PTO clutch indicator (1) comes on while PTO
clutch control switch is engaged "ON" and goes off
when disengaged "OFF" it.
13
"INCREASE"
"DECREASE"
"START" (Engine-Start)
the indicator lamp