Installation; Hardware Installation - Vivotek 3GPP IP7131 User Manual

VIVOTEK - A Leading Provider of Multimedia Communication Solutions

Installation

In this manual, "User" refers to whoever has access to the Network Camera, and
"Administrator" refers to the person who can configure the Network Camera and grant
user access to the camera.

Hardware installation

Upon powering up, the front blue LED will become lighted first and then the device will go
Status LED Color
through booting process. During the booting process, both blue and red LEDs will be on
Blinking red
and the Network Camera will standby for getting IP address. After getting IP Address, the
Solid green
LED will blink blue every second.
Solid green with blinking red in between
Solid green and red
The Network Camera will first detect Ethernet. During the process, the red LED of the
Solid red with blinking green in between
Blinking red and green
Network Camera will flash every second. Operating in either network mode, the blue LED
will flash every second as heartbeat to indicate alive.
To install in Ethernet
Make sure the Ethernet is firmly connected to a switch hub. After attaching the
To install in Ethernet
Ethernet cable plug in the power adapter. When the red LED is lighted and the green
Make sure the Ethernet is firmly connected to a switch hub. After attaching the Ethernet
LED blinks every other second in between, indicating the camera is working, please
cable plug in the power adapter. If the LED turns out to be steady blue, go to next
go to next paragraph "Software installation". If the Ethernet is not available, Network
paragraph "Software installation". If the Ethernet is not available, Network Camera will
Camera will switch to wireless LAN mode.
 - User's Manual
Please verify that your product package contains all the
accessories listed in the foregoing Package Contents.
Depending on the user's application, an Ethernet cable
may be needed. The Ethernet cable should meet the specs
of UTP Category 5 and not exceed 100 meters in length.
Connect the power adapter jack to the Network
Camera before plugging in to the power socket. This will
reduce the risk of accidental electric shock.
Description
Power is being supplied to the camera.
The camera is booting up.
The camera is trying to obtain an IP address.
An IP address is successfully assigned to the camera.
The camera is working.
During firmware upgrading
- 7 -
www.vivotek.com