Cd Programmed Operation; General Cd Operation - Jensen CD-555 User Manual

NOTE: This player plays not only commercial CDs but also self-compiled CD-R/RW discs.
1. Press the POWER ON/OFF Button (#1) once to turn on CD-555. The POWER
INDICATOR (#3) will light.
2. Set the FUNCTION SELECTOR (#14) to "CD" position. The player will start reading
TOC of the disc and will display "no" if no disc is loaded.
3. Open the CD Door (#18). Carefully place an audio CD with its label side upward in
the CD compartment (#19) and close the CD Door (#18).
4. The total number of tracks on the CD will appear in the LED Display (#2) after a few
seconds.
5. Press the Button (#11). The PLAY INDICATOR (#16) will light and the CD will
start playing from the first track.
6. Adjust the Volume Control (#17) to obtain the desired sound level from the Built-in
Speakers.
7. To suspend playing, press the
flash. To resume playing, press the
8. You can choose to play your favorite track directly by pressing either the
(#12) or Buttons (#9). The LED Display (#2) will indicate the correct track
number selected.
9. To locate a particular passage within a track, keep the
Buttons (#9) depressed until it is found.
NOTE: Low level audio will be heard during the search process to assist in locating correct
point in the track.
10. To repeat a particular track, press the REPEAT Button (#7) once or until the REPEAT
INDICATOR (#5) flashes.
11. To repeat the entire CD, press the REPEAT Button (#7) twice or until the REPEAT
INDICATOR (#5) lights steadily.
12. To stop playing, press the STOP
13. When you wish to turn off the CD PLAYER, press the POWER Button (#1) again. The
POWER INDICTOR (#3) will light off.
This function allows the tracks to be played in a programmed sequence.
1. In CD stop mode, press the PROG. Button (#8) once. The CD PROG.
INDICATOR (#4) will flash and Program Channel Number "01" will
appear and blink in the LED Display (#2) to prompt for input.
2. Press the
programmed. For example track 8 is selected.
3. Press the PROG. Button (#8) again to store selectio
Channel No. will change to "02" and blink to prompt for input
4. Press the (#12) or
programmed and press the PROG. Button (#8) to store selection. For
example the second selection is track 15.
CD OPERATION
Button (#11) again. The PLAY INDICATOR will

CD PROGRAMMED OPERATION

(#12) or (#9) Buttons to select the song to be
(#9) Buttons to select the next song to be
Button (#11) again.
Button (#10).
n. The Program
E-6
button
button (#12) or
0 1
8
0 2
1 5