Battery Replacement; Radio Operation; Play Mode - Jensen CD-475 User Manual

Portable cd player with am/fm stereo radio
Hide thumbs Also See for CD-475:
Table of Contents

Advertisement

BATTERY NOTE AND CARE
1. Danger of explosion if the battery is replaced incorrectly. Replace only with the same or
equivalent type
2. Do not mix old and new batteries.
3. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
4. If the unit is not to be used for an extended period of time, remove the batteries. Old or leaking
batteries can cause damage to the unit and may void the warranty.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture.
(Follow battery manufacturer's directions).
6. Do not dispose of batteries in fire, batteries may leak or explode.

BATTERY REPLACEMENT

When the output sound of this unit becomes distorted or the CD player operation appears unstable,
the batteries are weak. You need to replace all the exhausted batteries at the same time as soon
as possible to avoid battery leakage.
1.
Slide the FUNCTION SWITCH to AM or FM position.
2.
Rotate the TUNING CONTROL KNOB to your desired radio station according to the DIAL
SCALE on the knob.
3.
Rotate the VOLUME CONTROL KNOB to adjust to the desired output level.
4.
To turn off the radio, slide the FUNCTION SWITCH to "OFF" position.
TIPS FOR BEST RECEPTION
AM – The AM antenna is located inside the cabinet of the unit. If AM reception is weak, change the
position of unit until the internal antenna picks up the strongest signal.
FM – If a stereo broadcast program is being received, the FM STEREO INDCATOR will light.
During FM or FM Stereo reception, always keep the FM TELESCOPIC ANTENNA fully
extended for best performance. However, if FM reception is weak, try repositioning the unit
near an open window until you get the best reception.
NOTE: This unit not only plays commercial compact discs but also self-complied CD-RW discs.
Because of non-standardized format definition/production of CD-R/RW, playback quality &
performance is not guaranteed.
Manufacturer is not responsible for the playability of CD-R/RW due to recording conditions
such as PC performance, writing software, media properties etc.
Do not attach a label or seal to either side of the CD-R/RW disc. It may cause a
malfunction.

PLAY MODE

1.
Slide the FUNCTION SWITCH to the "CD" position.
2.
Open the CD DOOR, load a CD with the label side facing upward and then close the CD door.

RADIO OPERATION

CD OPERATION
E-8

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents