Related Manuals for Etesia AK 51
Summary of Contents for Etesia AK 51
- Page 1 User Manual Please read carefully before using your machine (Translation of the originals instructions manual) AK 51...
-
Page 2: Table Of Contents
ConTenTs AK 51 Brush-cutter Your safety and that of others ............................... 3 Key to diagrams .................................... 5 Descriptions ....................................7 Pictures ......................................8 Technical specifications ................................9 Preparation and getting started ..............................10 Operating instructions ................................. 11 Maintenance ....................................12 Winter storage - long stop ................................ -
Page 3: Ak 51 Brush-Cutter
• ETESIA has a policy of continuously improving the quality of its and averagely maintained, where a lawnmower is no longer totally products. - Page 4 • Do not transport the brush-cutter with fuel in the tank or when the • no responsibility will be accepted by ETESIA in the case of failure fuel cock is open. to comply with these instructions.
-
Page 5: Key To Diagrams
2• KEY To DIAgrAMS - SAfETY sAfeTy lAbels lAbel A a. CAuTIon ! b. Before using, please read and follow the safety and maintenance instructions of the instruction booklet lAbel b This symbol appears in the instruction manual alongside c. finger cut risks those sections which deal with user safety. - Page 6 2• KEY To DIAgrAMS - uSE • EnginE spEEd • dRiVE COnTROL LEVER START position: to start with cold engine - To move forward, push the control lever against the handlebar. Maximum run - To stop, release the control lever. • bLadE CLuTCh COnTROL LEVER STOP position: to stop the engine blADe 1 - Press the upper safety lever against to the handlebar.
-
Page 7: Descriptions
3• DESCrIPTIonS • 1. Drive lever • 13. fuel cock • 2. The blade clutch • 14. Starter • 3. gas lever • 15. Air filter • 4. Speed selector lever • 16. Spark plug • 5. Differential lock lever •... -
Page 8: Pictures
4• PICTurES MAXI 20°... -
Page 9: Technical Specifications
: 0 - 3,0 forward2 : 0 - 4,0 forward3 : 0 - 5,0 kph/gbox reverse : 0 - 4,0 kph Weight 85 kg Blade ETESIA reference TZ 51 A Vibration level at the handle < 2,5 m/s reference standard for measurements : En 836, En 1033, Sound pressure at driver’s seat... -
Page 10: Preparation And Getting Started
6• PrEPArATIon AnD gETTIng STArTED • Bring the handlebars back to the working position. • Start the brush-cutter in a clear area. • Swing the locks to abut against the handlebars and tighten the nut- • never tilt it to start the engine or when the blades are rotating. knobs. -
Page 11: Operating Instructions
7• oPErATIng InSTruCTIonS ADjUsTIng The CUTTIng heIghT sTARTIng AnD sToPPIng (PICTURe 3 PAge 8) fORwaRd dRiVE Proceed only after engine has been switched off and blade dRiVE COnTROL has come to a complete standstill. To move • hold the adjustment lever firmly, tighten the lever to ensure •... -
Page 12: Maintenance
• If you notice anything that is not working properly, have the safety on its side. system checked by an approved ETESIA service engineer. • Collect the used oil in a receptacle as it comes out of the filler neck sToRAge (picture 5 page 8). -
Page 13: Winter Storage - Long Stop
• Turn the engine over slowly (with the blade) for about ten turns • of course, you may have such seasonal maintenance carried out by so as to spread the oil and protect the cylinder and valves from an approved ETESIA dealer. corrosion. • replace the spark plug. -
Page 14: Day To Day Maintenance - Breakdowns And Solutions
The following table describes simple methods of identifying a few malfunctions and correcting them. If the problem persists, we recommend that you contact one of our approved ETESIA dealers (list on request from ETESIA 67165 WISSEMBourg Cedex - france or ETESIA uK Limited, CV34 5hg WArWICK). -
Page 15: Warranty
,clutchs,batteries,battery electrolytes, control cables,sheath,fuel • Should ETESIA discover that the machine is not used in the use pipes,durits,cooling liquid, hydraulic and lubrication liquids,fuel initially declared, ETESIA allows itself to cancel the warranty. - Page 16 13, rue de l’Industrie, 67165 WISSEMBourg CEDEX declare under our responsibility that the petrol lawnmower, type Attila, reference AK 51, to which this declaration refers, fulfil all the relevant terms of directive 2006/42/EC applicable to them as well as to the provisions of all other directives European applicable to them : - EC 2004/108 Electromagnetic compatibility.
- Page 17 Stamp here please ETESIA SERVICE GARANTIE 13 rue de l'Industrie 67165 WISSEMBOURG CEDEX France...
- Page 18 This card has to be returned completed to ETESIA upon the first setting up. WARRANTY CERTIFICATE Serial number USER NAME ___________________________ Forename _________________________ Street ___________________________ Zip code __________________________ Town ____________________________ Date of purchas _____ _____ 20 ___ Month Year Tel. number ______________________...
Need help?
Do you have a question about the AK 51 and is the answer not in the manual?
Questions and answers