Makita 9523NB Technical Information page 3

R
epair
(1) Replacing of armature
1) Disconnect the wheel and wheel cover, respectively.
2) Disconnect the carbon brush.
3) Disconnect the tapping screw PF5x25 for holding the gear housing and motor housing and then remove the
armature.
Tapping screw PF5X25
4) To disassemble the armature from the gear housing, depending on the
position its sometime hard to pull out the armature due to touching
between the protrusion of circle clip and spiral bevel gear 36. In such
a case slightly turn the armature to slide it before disassembling.
Gear housing
Bearing retainer
Motor housing
Carbon brush
Holder cap
Spiral bevel gear 36
Protrusion of circle clip