Vfr - Honeywell BendixKing KT 76C Installation Manual

B
B. ID CODE
The 4096 Identification code, ID code, for the aircraft is displayed in the right
hand position of the display, the Ident window. There are eight pushbutton
switches (0 through 7) used to select the 4096 ID code.
The ID code may be selected in the Standby, On, and Altitude modes. Three
to four seconds after the ID code has been selected or immediately after the
"IDT" pushbutton has been pressed the new code is transmitted. The ID code
is written into nonvolatile memory so that the code will be saved during power
interruptions.
C. VFR (see
Momentarily depressing the "VFR" pushbutton causes the pre-programmed
VFR code to supersede whatever code was previously entered. The ID code
will be immediately displayed and transmitted 4 to 6 seconds later. This ID
code will be stored as the last active ID code just as if it were entered from the
front panel (see
The VFR code is programmed by the following sequence:
Rev 3, May 2004
ATCRBS TRANSPONDER
FIGURE 3-6 Ident
Figure 3-7)
Figure 3-7).
IM 006-10545-0003.dwd
KT 76C
Page 3-4