Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Progression Fitness Manuals
  4. Elliptical Trainer
  5. E800m
  6. Operating manual

Progression Fitness E800m Operating Manual

Hide thumbs

Advertisement

Quick Links

Download this manual
E800m Elliptical
Owner's Operating Manual

Advertisement

loading

Related Manuals for Progression Fitness E800m

Summary of Contents for Progression Fitness E800m

  • Page 1 E800m Elliptical Owner’s Operating Manual...
  • Page 2 (M1) (M2) M4X18L Small handlebar Bracket - 1 -...
  • Page 3 FIGURE 1 - ASSEMBLY FOR FRONT FOOT AND REAR FOOT Step 1. Assemble the front foot (C) with the base frame (A) by using the bolts (C3), washers (C4), spring washers (C5) and nuts (C6). Step 2. Assemble the rear foot (D) with the base frame (A) by using the bolts (D3), washer (D4), spring washers (D5) and nuts (D6).
  • Page 4 FIGURE 3 FIGURE 3 - ASSEMBLY FOR CENTRAL TUBE Step 1. Connect the sensor wire (A2) and the computer cable (F2). Step 2. Equipment the cable of tension control (F3) in the slot of tension cable plastic bracket (A3) as shown in View A-1. Fit the large and small brass barrels together and tighten by turning with your fingers as shown in View A-2.
  • Page 5 FIGURE 4 FIGURE 4 - ASSEMBLY FOR SMALL HANDLEBAR Step 1. Assemble the small handlebar (E) with small handlebar bracket (L5), M6 washers (L4), spring washers (L3) and screws (L2). Step 2. Slide the hand pulse sensors (E5) through the hole of support tube (F) and out the top of the support tube.
  • Page 6 FIGURE 6 FIGURE 6 - HANDLEBAR ASSEMBLY Step 1. Take off the bolt (H4), spring washer (H3) and washer (H2) from the axle tube (H1) before assembly. Step 2. Push axle tube (H1) into the middle of the tube welded at right angles to supporting tube (F). Step 3.
  • Page 7 FIGURES 7-8 FIGURE 7 - CONNECTING TUBE ASSEMBLY Step 1. Equip the connection tube (A9) with the handlebar (B2) and fix by knob (L6). Step 2. The same procedure as left side. ** 4 position height adjustment FIGURE 8 - ASSEMBLY FOR SIDE HANDLEBAR JOINT COVERS Step 1.
  • Page 8 FIGURE 9 FIGURE 9 - FOOT REST ASSEMBLY Assemble the foot rest (K2) by screw (L1), washer (L4), spring washer (L3) and star knob nut (L7). There are 3 sections adjusting for the moving track. If you find the end cap of the front tube and rear tube are not nestled against the ground, you can change the angle of the end cap of rear tube (D2).
  • Page 9 - 8 -...
  • Page 10 - 9 -...

  • Page 12: Function Button

    FUNCTION BUTTON MODE: 1. To have each function display on the monitor. 2. Press “MODE” and hold for 2 seconds to reset all function figures. FUNCTIONS SCAN Distance and calories will switch to each other every 6 seconds automatically after you start training. SPEED Displays current training speed, the maximum is 99.9 km/ml.