Data Plate - Bosch HGS7022UC-01 Use And Care Manual

Service
Table 12: Oven Troubleshooting Chart
Oven Problem
Oven light will not turn off
Cannot remove lens cover on light
Oven will not Self-Clean properly
Clock and timer are not working properly
Porcelain chips
"F" and a number appears in display and
control beeps
With a new range there is a strong odor
when oven is turned on
Control does not react when the pad is
touched
Fan is not running during a convection
mode
Fan turns off and on during the cycle
Fan is running during modes that don't
use convection
Warm air or steam escapes from oven
vent
How to Obtain Service or Parts
Product Data Plate
English 40
Check for obstruction in oven door. Check to see if hinge is bent. When the
Sabbath feature is activated, the oven light will stay on or off (as selected
during set-up) during the entire Sabbath mode.
There may be soil build-up around the lens cover. Wipe lens cover area
with a clean dry towel prior to attempting to remove the lens cover.
Allow the oven to cool before running Self-Clean. Always wipe out loose
soils or heavy spillovers before running Self-Clean. If oven is badly soiled,
set oven for a five-hour Self-Clean. See Preparing the Oven to Self-Clean.
Make sure there is electrical power to oven. See Clock and Timer sections.
When oven racks are removed and replaced, always tilt racks upward and
do not force them to avoid chipping the porcelain.
This is a fault code. Press Off to clear the display and stop beeping. Reset
oven if necessary. If fault code remains and beep continues, record fault
code, cancel oven and call authorized service technician.
This is normal with a new range and will disappear after a few uses. Oper-
ating the self-clean cycle will also "burn-off" the smell more quickly.
Be sure that pad is clean. Touch the center of the touchpad. Use the flat
part of your finger.
On some modes, the convection fan does not come on at the beginning of
the cycle. This is normal. If the fan is not running at the beginning of the
cycle, wait 15 minutes and then check again. If the fan is still not running,
call service.
The convection fan turns off while the oven door is open. It resumes when
the door is closed again.
On some models, the convection fan will run while the oven is preheating
for the bake mode. This is normal.
It is normal to see or feel steam or warm air escaping from the oven vent.
Do not block the vent.
To reach a service representative, see the contact information at the front of the
manual. Please be prepared with the information printed on your product data
plate when calling.
The data plate shows the model and serial number. Refer to the data plate on the
appliance when requesting service. It is located on the frame near the drawer.
Open the drawer to view it.

Data Plate

Possible Causes and
Suggested Solutions
Figure 18: Data Plate