Table of Contents
Advertisement
XTD 1.9 Installation and Operation Manual
Appendix 3: Installation and Use of the Optional Air Circulation
Blower and Thermodisc
An optional blower can be installed on the back of the stove to increase the flow of air past
heat exchange surfaces and to help circulate warm air in the room. When used regularly,
the blower can provide a small increase in efficiency, up to 2 percent. However, the use of
a blower should not be used as a way to gain more output from a stove that is undersized
for the space it is intended to heat. You can purchase this option through your FLAME
dealer. Make sure to specify this part number: # AC03095
When using the optional blower, allow the stove to reach operating temperature
(approximately one hour), before turning it on. The increased airflow from the blower cools
the firebox and could affect the start-up combustion efficiency if the blower is turned on too
early. You can also install a thermodisc to enable the blower to start or stop automatically
when the stove is hot or too cold. The thermodisc part number is AC05530. Installation
instructions are supplied with the blower and the thermodisc.
45
Advertisement
Table of Contents
