Updating and Setting Profiles
General
Updating and setting profiles require:
Source computer
1. To perform Export all profiles.
2. To send the profiles and MTU.exe to the target computer.
Target computer
1. To run the profile setting update process.
Detailed Procedure
Preparing the Profiles Package
1. Activate the MCU.
2. Configure the required profiles (refer to "Configuring a new profile" on page 32).
3. Using the Action drop-down menu, select Export All. The following message appears:
62
The following activities are done on
the station that is sending the
profiles update.
NOTE
Before attempting to perform the
next step, verify that the Profile
Management tab of your MCU is
NOTE
pressed.
Appendix B - Over the Air Programming