Installing Your New Appliance - AEG S76010CMX2 User Manual

5.

INSTALLING YOUR NEW APPLIANCE

This section explains the installation of
the new appliance before using it for the
first time. We recommend reading the
following tips.
WARNING!
F o r p ro p e r i n s t a l l a t i o n , t h i s
refrigerator must be placed on a
level surface of hard material that
is the same height as the rest of
the flooring. This surface should
be strong enough to support
a fully loaded refrigerator, or
approximately 266 lbs. (120 kg).
When moving, be sure to pull out
and push back the unit in straight.
Class
Extend
Temperate
Temperate
Subtropical
Tropical
Ambient
Symbol Temperature
rage(°C)
SN +10 to +32
N +16 to +32
ST +16 to +38
T +16 to +43
This appliance is sold in France. In
accordance with regulations valid in
this country it must be provided with
a special device (see figure) placed in
the lower campartment of the fridge to
indicate the coldest zone of it.
Leveling of appliance
For proper leveling and avoid vibration,
this appliance is provided with adjustable
feet in front. Please adjust the level by
following below instructions:
1. Roll the refrigerator into place.
2. Turn the adjustable feet (with your
fingers or a suitable spanner) until they
touch the floor.
3. Tilt back the top backwards for about
10-15 mm by turning the feet 1~2 turn
further. This will allow the doors to self-
close and seal properly.
4. Whenever you want to move the
appliance, remember to turn the feet
back up so that the appliance can roll
freely. Reinstall the appliance when
relocating.
Front roller
Adjustable foot
WARNING!
The rollers, which are not castors,
should be only used for forward
or backward movement. Moving
the refrigerator sideways may
damage your floor and the rollers.
ENGLISH
10-15mm
Rear roller
7