Toyota 2004 Rav4 Owner's Manual page 187

3. Simultaneously press and hold
hand- held garage transmitter
along with the selected HomeLink
ton.
4. When the indicator light
R
HomeLink changes from a slow to a
rapid flash after 20 seconds, you can
release both buttons.
5. Test the operation of the HomeLink
pressing the newly programmed button.
If programming a garage door opener,
check to see if the garage door opens
and closes.
If the garage door does not operate, iden-
tify if your garage transmitter is of the
"Rolling Code" type. Press and hold the
R
programmed HomeLink button. The ga-
rage door has the rolling code feature if
the indicator light (on the HomeLink
flashes rapidly and then remains lit after
2 seconds. If your garage transmitter is
the "Rolling Code" type, proceed to the
heading "Programming a rolling code sys-
tem".
6. Repeat steps 2 through 5 for each re-
R
maining HomeLink button to program
another device.
the Programming a rolling code system
button
If your device is
R
but-
equipped, it is necessary
steps 1 through 4 under the heading
on the "Programming the HomeLink
proceeding with the steps listed below.
1. Locate the "training" button on the ceil-
ing mounted garage door opener motor.
R
by The exact location and color of the
button may vary by brand of garage
door opener. Refer
guide supplied by the garage door
opener manufacturer for the location of
this "training" button.
2. Press the "training" button on the ceil-
ing mounted garage door opener motor.
Following this step, you have 30 seconds
in which to initiate step 3 below.
R
)
3. Press and release the vehicle's pro-
grammed HomeLink
garage door may open. If the door
does open, the programming process is
complete. If the door does not open,
press and release the button a third
time. This third press and release will
complete the programming process by
opening the garage door.
'04 Rav4_U (L/O 0403)
The ceiling mounted garage door opener
motor should
"Rolling Code"
R
HomeLink
to follow
garage door up/down.
R
" before 4. Repeat steps 1 through 3 for each re-
maining HomeLink
another rolling code system.
Programming an entrance gate/program-
ming all devices in the Canadian market
1. Decide which of the 3 HomeLink
to the owner's
tons you want to program.
2. Place
transmitter 25 to 75 mm (1 to 3 in.)
away
HomeLink
Keep the indicator light on the HomeLink
in view while programming.
3. Press
HomeLink
R
button twice. The
4. Continuously press and release (cycle)
the hand- held gate/device transmitter
button every two seconds until step 5
is complete.
5. When
HomeLink
rapid flash after 20 seconds, you can
release both buttons.
2004 RAV4 from Mar. '04 Prod. (OM42568U)
now recognize the
unit and be able activate the
R
button to program
R
but-
your hand- held gate/device
from the surface of the
R
.
R
and hold the selected
R
button.
the indicator light on the
R
changes from a slow to a
179