Table of Contents
Advertisement
182
Vehicle care
2. Unscrew the two plastic securing
nuts from the inside by hand.
3. Carefully withdraw the light
assembly from retaining pins and
remove. Make sure that the cable
duct remains in position.
4. Detach the wiring plug from the
bulb carrier.
5. Unlatch the four retaining lugs and
remove the bulb carrier.
6. Remove and replace the bulb.
Tail light and brake light (1)
Tail light (2)
Turn signal light (3)
Version with Light Emitting Diode
(LED):
Only brake light (1) and turn signal
light (2) can be changed.
7. Insert the bulb carrier into the tail
light assembly. Connect the
wiring plug. Fit light assembly
onto retaining pins and tighten the
securing nuts. Close the cover
and engage.
8. Switch on the ignition, operate
and check all lights.
Advertisement
Chapters
Table of Contents
