Car rear view mirror monitor with 7.3 inch wide lcd display screen (12 pages)
Summary of Contents for Germid FK-073A
Page 1
ECER10 ECER46 Approval No.: 10R-03 12762 Approval No.: 46R-04 0019 Car Rear View Mirror Monitor with 7.3 Inch Wide LCD Display Screen User manual FK-073A Designed in Grand Rapids MI, USA Assembled in China...
1.4 Operating panel Chapter one: Product Introduction 1.1 Package The packing box contains the following accessories, please confirm: ● Car rear view mirror monitor with 7.3 inch wide LCD display screen ● wire harness ● User's manual ● wire cover ●...
Page 4
Horn Connector Special bracket Red to ACC+ Black to GND Turn left signal (option) Turn right signal (option) Back up signal Video input Camera Video input Connector cover Cable cover...
2.2 Special bracket Chapter two: Installation and Wiring 2.1 How to install Remove the original mirror Remove the original rear view mirror and remain Original car rear view mirror the metal base on the windscreen Different cars have different brackets. It depends on your vehicle maker and manufacturer.
2.3 How to wire By connecting the green line, the reversing signal is input to the rear view mirror and reversing video can automatically display on the wide 7.3 inch LCD monitor. The advisable installation position for camera Black to GND Red to ACC +12V CTR1(Green) Back up video...
2.4 How to display the rear view mirror screen. Status D (option): When the car is turning to right, the right light is on, and turning right signal would trigger automatically the right camera to get the full screen. After it closes for 3S, the screen would get back. Status A: In normal driving, the car monitor can display left and right video, to facilitate drivers to observe the condition of the two sides (There will be different video displayed on mirror according to the different location of...
4.2.1 BRIGHTNESS ADJUSTMENT Chapter Four: Menu Setting The defaulted setting is 50, ranging from 0 to 100, and only CVBS signal can work. 4.1 Remote control The menu only can be set by remote control, and kindly check its definition as below. Menu parameter increase Enter picture menu Menu parameter decrease...
Page 9
Chapter three: Adjustable Guideline 3.3 How to adjust the guide line According to the site of standard reference line, we can put reference objects such as desks in the back area of car. Compared with the marked reference objects, we 3.1 About guide line can adjust the sites and angle of two guide lines displayed on the monitor.
Page 10
4.2.4 SCALE ADJUSTMENT It's only for the model with guide lines, and no such setting for those without such function. ON is defaulted setting, and you can manually set it to OFF. 4.2.5 START LOGO ADJUSTMENT It's is defaulted as “ON”, you can set it to “OFF” manually. 4.2.6 PRESET ADJUSTMENT It's defaulted as OFF, and ON is to preset the menu, then it switches to OFF automatically.
Need help?
Do you have a question about the FK-073A and is the answer not in the manual?
Questions and answers