Motorola Phone i500plus User Manual page 48

i500plus User's Guide
Desktop Charger Troubleshooting
If the battery is not charging and you see:
A flashing yellow indicator -
• The flashing yellow LED is used to indicate that the Charger's
pocket is in a wait state.
• If a battery is in the rear pocket, the rear pocket's LED
continues to flash yellow until the battery in the front pocket is
more than 90% charged (front pocket's LED is solid green).
This is normal operation.
• To protect your battery's life expectancy, the Charger does not
rapid charge a battery when its temperature is below 5
o
(41 F) or above 45
No LED indication -
• Check that the i500plus with battery, or a battery alone, is
inserted correctly.
• Make sure that the power supply is plugged into an appropriate
AC outlet and that the connector is properly seated.
• Rear pocket only: Remove the battery from the Charger. Use an
ordinary pencil eraser to clean the three metal contacts on the
battery and then place the battery in the Charger.
• If the LED indicator remains turned OFF, the battery may be
defective and should be replaced.
Flashing red LED indicator -
• Remove the battery from the Charger. Use an ordinary pencil
eraser to clean the three metal contacts on the battery and then
place the battery in the Charger.
• If the LED indicator remains turned OFF, the battery may be
defective and should be replaced.
Both LEDs flash red -
• This indicates that the incorrect power supply is plugged in.
42
o o
C (113 F).
o
C