Tilt Steering Wheel - Toyota 2003 Corolla Owner's Manual

CHILD RESTRAINT SYSTEM
INSTALLATION
Type A—
1. Widen the clearance between
seat cushion and seatback a little
and confirm the position of the low-
er anchorages near the tag on the
seatback.
2. Latch the hooks of lower straps onto
the anchorages and tighten the lower
straps.
Type B—
1. Widen the clearance between
seat cushion and seatback a little
and confirm the position of the low-
er anchorages near the tag on the
seatback.
2. Latch the buckles onto the anchor-
ages.
If your child restraint system has a top
strap, it should be anchored. (For the
installation of the top strap, see "—Using
a top strap" on page 65 in this section.)
For the installation details, refer to the in-
struction manual equipped with each prod-
uct.
68
'03 Corolla U (L/O 0201)
CAUTION
When using the lower anchorages
D
the
for the child restraint system, be
sure that there are no irregular ob-
jects around the anchorages and
that the seat belt is not caught.
Push and pull the child restraint
D
system in different directions to
make sure it is secure. Follow all
the installation instructions
vided by its manufacturer.
Do not install a child restraint sys-
the D
tem on the rear seat if it interferes
with the lock mechanism of the
front seats. This can cause death or
serious injury to a child and front
passenger in case of
braking or collision.
2003 MY COROLLA_U (OM12744U)

Tilt steering wheel

pro-
To change the steering wheel angle,
hold the steering wheel, push down the
lock release lever,
wheel to the desired angle and return
the lever to its original position.
a sudden
tilt the steering