Toyota 2003 Corolla Owner's Manual page 25

Hide thumbs Also See for 2003 Corolla:
Table of Contents

Advertisement

SETTING THE SYSTEM
You can set the system as follows.
1. Remove
the
key
from
the
switch.
2. Have all passengers get out of the
vehicle.
3. Close all the doors and trunk lid secu-
rely.
4. Lock all the doors with the key or wire-
less remote control transmitter. At this
time, the TVIP indicator light comes
on.
The system will be set in 30 seconds.
When the system is set, the indicator
light will start to flash.
5. Make
sure
that
the
flashes. Then you may leave the ve-
hicle.
Never leave anyone in the vehicle when
you set the system because unlocking
from the inside activates the alarm.
Activating the alarm
If the system detects a threat to the
vehicle, it sounds the alarm for one
minute while flashing headlights and
turn signal lights. Also, the interior
light turns on when the interior light
dial is in the DOOR position.
The system detects a threat under any of
the following conditions:
Either of the front doors is unlocked by
ignition
D
means other than the key or wireless
remote control transmitter.
If the key is not in the ignition switch,
all
the
doors
will
locked again.
Any of the doors or trunk lid are forci-
D
bly opened.
The alarm will activate when the trunk
lid is opened with a key. Cancel the
system before opening the trunk lid.
2003 MY COROLLA_U (OM12744U)
'03 Corolla U (L/O 0201)
indicator
light
The side windows are tapped or bro-
D
ken.
The battery terminal is disconnected
D
and then reconnected.
The ignition is hotwired.
D
After one minute, the alarm automatically
stops and the indicator light starts flashing
again.
Reactivating the alarm
Once set, until you cancel the system, the
system automatically resets the alarm af-
ter the alarm has stopped.
The alarm will activate again under the
same circumstances described in "Activat-
ing the alarm".
Stopping the alarm
You can stop the alarm in either of the
following ways:
be
automatically
Unlock any of the doors with the key
D
or wireless remote control transmitter.
Place the ignition switch in the "ON"
D
position.
21

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents