Blaupunkt 40/148Z-GB-5B2-FGKU User Manual page 7

ATTACHING THE STAND
Attaching the stand for 50" models only
To complete the stand installation you will require a cross head screw driver
There are two types of screws provided as shown below.
7 x M (4x16)
Used for attaching the stand neck
to the TV (fi g.1)
7 x
M (4x16)
1
1 1/2
2
3
10
5 x ST (3.7x20)
Used for attaching the stand base
to the stand neck (fi g.3)
(fi g.1) Attach the stand neck to the rear of the TV set
using the 7 x M(4x16) screws provided.
(fi g.2) Peel off the protective plastic cover then attach
the stand base to the stand neck.
When securing the self-tapping screw/s into the base of the stand (on
fi rst installation) the screw/s will be naturally tight as they create a
thread in the plastic of the stand neck in order to support a TV of this size.
a) Ensure the cross head screw driver tip fi ts correctly into the head of the
5 x ST 3.7x20
screw and that it is not too big or small.
b) Screw in all screws individually and partially before tightening all of the
screws fully.
c) If they become very tight try loosening them slightly and then re-tightening
them once again as this will continue the process of creating the thread for
the screws.
(fi g.3) Secure the base to the neck by using the
5 x ST (3.7x20) screws provided.
Attaching the Stand