Power Liftgate - GMC Yukon Denali 2016 Getting To Know Manual

Remote Keyless Entry Transmitter (Key Fob)
Unlock
Press to unlock the driver's door.
Press again to unlock all doors.
Lock
Press to lock all doors.
Note: Press and hold the Lock/Unlock buttons
to automatically fold/unfold the power mirrors.
To change the Auto Mirror Folding setting, go to
Comfort and Convenience in the Vehicle Settings
menu.
Liftglass
Press twice to open the liftglass.

Power Liftgate

Press twice to open or close the
power liftgate.
Vehicle Locator/Panic Alarm
Press and release to locate your vehicle.
The turn signal lamps will flash and the
horn will sound.
Press and hold to activate the alarm. The turn
signal lamps will flash and the horn will sound
until the button is pressed again or the ignition
is turned on.
Power Liftgate
Open/Close the Power Liftgate
Press the Power Liftgate button on
the RKE transmitter twice.
Power Liftgate knob on
Press the
the overhead console.
Press the touchpad on the liftgate han-
dle to open the liftgate.
Press the button next to the liftgate
latch to close the liftgate.
Hands-Free Operation
To open or close the liftgate hands-free,
kick your foot straight in and out under
the center of the rear bumper. Do not
swing your foot side-to-side. The RKE
transmitter must be within 3 feet of
the liftgate.
4
F
Optional equipment
Remote Vehicle Start
Press and release the
and then press and hold the
until the turn signal lamps flash (about
4 seconds) to start the engine from out-
side the vehicle. After entering the vehicle,
turn on the ignition.
• During a remote start, the engine will
run for 10 minutes.
• Remote Start can be extended once by
repeating the remote start procedure.
• Press and hold the
the parking lamps turn off to cancel a
remote start.
• The heated/cooled seats will turn on
during a remote start (if selected in the
Vehicle Settings menu) when outside
temperatures warrant.
Note: To program the remote lock, unlock, and
remote start settings, go to Remote Lock, Unlock,
Start in the Vehicle Settings menu.
See Keys, Doors and Windows in your Owner Manual.
Programming the Liftgate Height
1. Turn the Power
Liftgate knob to the
3/4 mode position.
2. Open the liftgate.
3. Adjust the liftgate
manually to the
desired height.
4. To save the setting, press and hold the
button next to the liftgate latch for
3 seconds. The turn signals will flash
when the setting is saved.
See Keys, Doors and Windows in your Owner Manual.
Lock button
button
button until