Table of Contents
Advertisement
-
6
-
connect
onto
Mounting
Plate
Assembly with Washers
(8)
and Nuts
(7).
Set
Base
on
Mounting Plate and fasten with Washers
(27)
and Screws
(28),
then place Bottom Cover
Assembly
(29)
on
Base and fasten with Screw
(28)
and
(30).
Install Adjustment Knob
(26)
onto main Adjustment Screw
at
the end of the Base.
C.
REPLACEMENT OF PARTS
1.
Base and Cord
-
Turn Toaster bottom side
up,
protecting Shell from being scratched.
Pry off Adjusting
Knob,
Key
No. 26.
Remove Screws
(28)
and Washers
(27)
from Base
(25)
along with Screws
(30)
from center
of
Hinge Plate
of
Bottom Cover Assembly. Lift Base
(25)
off
mechanism assembly
and remove Hex Nuts
(8)
with Washers
(7)
from Mounting
Plate Assembly
(20).
Separate Plug and Cord Assembly
(24)
from
Base.
Replace cord and
reassemble
2.
Clip
on
the
Bottom
Cover
Assembly
-
Remove
the
Bottom
Cover
Assembly
(29)
from
Toaster.
Drill out rivet
(29B)
with
a
3/32-inch drill and remove old
clip.
Set new
clip
(29A)
in
place,
insert rivet and swage with
a
punch.
3.
Center and End Shells
-
Remove Screws
(2)
and lift Center Shell
(1)
fro
mechanism.
Remove Screws
(2)
separating End Shells
(5)
from mechanism assembly.
Replace Shells
and reassemble.
4.
Thermostat Bracket
-
Set
mechanism assembly
so
that Thermostat Assembly
(12)
is
facing
up.
Remove Screws
(13)
and Washers
(8)
separating Switch Lead
(21)
and Upper Lead
Bracket
from
Thermostat
Assembly
(12).
Raise
Thermostat
Assembly
until
Reflector
clears window
in
element,
slide clear
of
mechanism assembly and
remove Nuts
(12L)
and
Spring Clip
(12Q)
from Thermostat Assembly. All parts
(12B to
12S inclusive)
are free
to be removed.
Replace Thermostat Assembly
(12A)
and reassemble.
If the
Thermostat Bracket
on the
model T20 Toaster requires changing will be necessary
to
modify
this
Toaster
to
a
model
T20B. To do this:
A.
Replace the Top End Plate
(3)
with
the Top End Plate of the model T20B Toaster.
B.
Bend and shorten the Guide Wires
(9)
to
same
shape
as the
model T20B Guide
Wires
C.
Drill
2
holes
in
the
hinge plate
of
the
Bottom Cover
(29)
to
fasten this
assembly
to the
upright
of the
Thermostat. Use
a
model T20B Bottom Cover
as
a
guide
to
locate the holes.
D.
Replace Screws
(30)
with Screws used on the Model T20A and T20B Toaster.
E.
Change model number
to
read T20B with stamping
dies.
Hide quick links:
Advertisement
Table of Contents
