Table of Contents
Advertisement
OPEL AP
10. You can now stand up the Opel AP again, then put
back the refractory liners and the doors.
After the facing is installed
1. Attach the control eye to the bypass rod by tightening
the setscrew with a 1/8" Allen wrench (Picture 13).
2. If the bypass rod is too short due to thick brick facing,
attach the extension. Measure the required length
from the threaded end and cut off excess before
installing the control eye.
3. Insert the handle into the control eye.
GOLD / PEWTER LOUVERS (FDL)
The standard black louvers above and below the doors
can be replaced with a gold plated louvers or pewter louvers
(OPLG) if you wish. You may order these from your deal-
er.
NOTE: There are 2 positions for the louvers: flush with
the front or protruding from the front.
Dismantling and assembling louvers
Figure 18b: Installation of the catalytic kit
1. The top louvers are held in place by springs under-
neath. Therefore, push down from the top and pull
out. To remove the bottom, remove the screw on each
side of the louvers.
2. Take the assembly apart by removing the top nuts
from the rods. Note that there are two washers under-
neath the top nuts on the bottom louvers. These
washers are placed to provide space for the air con-
trol lever. Make sure they go back when you
reassemble the louvers.
3. Assemble the new louvers the same way the old ones
came apart, reusing the original rods and spacers.
Leave about 1/4" of the rod protruding above the top
nut. Make sure you replace the washers under the top
nuts of the bottom louvers.
4. Put the reassembled louvers back into the fireplace.
NOTE: Although the gold plating will not tarnish, care
must be taken not to scratch the surface.
ROCK RETAINER KIT (FDK)
Facing
Facing material may only be non-combustible such as
metal, brick, rock, concrete board, or ceramic tile.
4
6
Page 19
5
7
Hide quick links:
Advertisement
Table of Contents
