Motorola ME4851 series User Manual page 56

Have your wireless headset close to the base station for the registering procedure.
1. Put your base in to registration mode - see your product user guide for instructions
on how to do this.
Note: On most GAP compatible, DECT phones you will normally have to press and
hold the PAGE key for several seconds. The PIN of most DECT or GAP phones is set as
"0000" as the default.
2. Once the base is in registration mode:
At the wireless Headset:
Press and hold the
flash alternately as your wireless headset searches for the base.
When the wireless headset successfully links with the base you will hear a
confirmation tone, the red light will go off and the green light will begin to
flash slowly.
Note: If registration fails, please refer back to the registration section of your telephone
user guide, check the PIN of the base is set to "0000" or "1234" or contact your
telephone Helpline.
Your wireless headset is now ready to use.
Key for 5 seconds. The red and green lights
55
55