Audio Physic RHEA II. The following safety instructions must be strictly observed: Only use or store the RHEA II in a dry place. Do not spill any kind of liquid on or insert any object into the subwoofer. If any liquid or object has entered your RHEA II, unplug the subwoofer immediately from the wall outlet and switch off all other equipment such as amplifier or multi- channel decoder.
Page 3
Adjust the subwoofer by rotating the spikes until they are firmly set on the ground and the RHEA II is level and stable. In a next step, tighten the lock nuts included in the delivery onto the spikes.
Use the supplied power supply cable to connect the mains socket of the subwoofer (2.6) to a wall socket. Turn the main power switch to position "ON" (2.5) in order to check the operability of your RHEA II. The indicator light will glow red.
Page 5
Connection to the amplifier of your multi-channel system: Connect the RHEA II like a regular passive loudspeaker in order to operate it in parallel with your main loudspeakers. Follow the instructions provided under a) in order to connect the left and right channel of the amplifier's loudspeaker terminals.
In order to switch the RHEA II back to the standby mode, press on the multifunction switch for about 3 seconds. When you set the power switch at the rear of the subwoofer to the “OFF” position, the power supply is completely cut off from the AC line.
Page 7
With this RHEA II to transmit the entire mode the crossover frequency frequency range provided by the setting is disabled, allowing the home cinema amplifier.
Page 8
The RHEA II features an automatic on/off sensing function for a more convenient operation. The subwoofer's standby function is automatically activated when there is no input signal to the RHEA II for more than 20 minutes. As soon as an input signal is detected, the subwoofer turns on automatically.
Page 9
Press the [MUTE] button for this. Adjustment In order to adjust the RHEA II to your main speakers and listening room, we recommend that you take the following steps: Switch on the RHEA II and play some well-recorded music with broad bass content through your system.
Page 10
Cleaning Before cleaning the RHEA II, unplug it from the AC outlet and switch off all other equipment (e.g. amplifier or multi-channel decoder). Only use a soft, clean cloth, moistened with a mild soap solution (but not wet!) to clean the subwoofer.
Check cables for the right connection and correct function. c) Switch off the RHEA II, allow the subwoofer to cool down, then switch it on again. Make sure the location of the RHEA II allows for sufficient air exchange and ventilation (see chapter “Set-up”).
Need help?
Do you have a question about the RHEA II and is the answer not in the manual?
Questions and answers