Lighting Dimmer - CITROEN 2015 Berlingo Multispace Handbook

Table of Contents

Advertisement

Instruments and controls
Zero reset
Your CITROËN dealer or a qualified 
workshop carries out this operation 
after each service.
However, if you carry out the service
yourself, the re-set procedure is as
follows:
-
switch off the ignition,
-
press and hold the trip recorder
reset button,
switch on the ignition.
The display begins a countdown.
When the display shows "=0", release
the button; the spanner disappears.
after this operation, if you wish to
disconnect the battery, lock the 
vehicle and wait for at least five 
minutes, otherwise the zero re-set will 
not be registered.
Engine oil level indicator
depending on your vehicle's engine,
when the ignition is switched on,
the engine oil level is indicated for
a few seconds, after the service
information.
Oil level
correct
Low oil level
Flashing of "OIL",
linked with the 
service warning lamp, 
accompanied by an 
audible signal and a message in the 
screen, indicates a low oil level which
could damage the engine.
If the low oil level is confirmed by a 
check using the dipstick, it is essential 
that the level is topped up.
Oil level gauge fault
Flashing of "OIL--"
indicates a
malfunction of the 
engine oil level
indicator. Contact a CITROËN dealer 
or a qualified workshop.
The level read will only be correct
if the vehicle is on level ground
and the engine has been off for
more than 30 minutes.
Dipstick
A = maximum, never exceed 
this level as a surplus of oil
may damage the engine.
Contact a CITRoËn dealer
or a qualified workshop 
without delay.
B = minimum, top up the level 
via the oil filler cap, using the 
grade of oil suited to your
engine.
Trip recorder zero
reset button
With the ignition on, press
the button until the zeros
appear.

Lighting dimmer

With the lighting on,
press the button to vary
the brightness of the
instruments and controls. 
When the lighting
reaches the minimum (or 
maximum) setting, release the button 
then press it again to increase (or
reduce) the brightness.
as soon as the lighting is of the
required brightness, release the button.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents