Battery Installation; Installing The Belt Clip - Midland X-Talker T50 Series Owner's Manual

Model T50 Series

BATTERY INSTALLATION

Your radio operates with either a NiMH battery pack or optional 3 AAA
alkaline batteries. The belt clip should be removed (see below) to
ease installation or removal of the batteries.
To install the batteries:
1. With the back of the radio facing you, remove the belt clip (see
diagram below) for easy access, then remove the Battery Cover by
pressing down on the top center and sliding it down from the radio.
2. Insert NiMH battery pack or 3 AAA batteries observing the polarity
as shown. Installing the batteries incorrectly will prevent the unit
from operating or may damage the unit.
3. Return the Battery Cover by sliding it up on the radio. Replace the
belt clip, making sure it locks into place.
BATTERY
COMPARTMENT
BATTERY
COMPARTMENT
COVER
Pr es s her e and
push do wn t o op e n

INSTALLING THE BELT CLIP

To install the BELT CLIP, slide the clip down into the slot on the back
of the radio until the BELT CLIP LATCH clicks. To remove the BELT
CLIP, pull the LOCK TAB away from the radio, then gently pull the
belt clip up toward the top of the radio.
Page 5
BELT CLIP
LOCK TAB
BELT CLIP
LATCH
midlandusa.com