JVC ks-fx834r Service Manual page 8

KS-FX834R
Removing the play head (See Fig.9)
* Prior to performing the following procedure, remove
the head relay P.W.B.and the sub chassis.
1. Remove the two screws F attaching the play head
(The spring under the play head comes off at the
same time).
Removing the pinch roller ass'y
* Prior to performing the following procedure, remove
the head relay P.W.B. and the sub chassis.
1. Push each tab i in the direction of the arrow and pull
out the pinch rollers on both sides.
Removing the reel disc P.W.B.
1. Unsolder the soldering j on the reel disc P.W.B.
2. Push the seven tabs k on the bottom of the cassette
mechanism assembly in the direction of the arrow.
Removing the motor and the sub motor
1. Unsolder the two soldering l of the motor and the sub
motor.
2. Release the sub motor from the three tabs m. Push
the sub motor upward and pull out it.
3. Remove the belt on the bottom of the cassette
mechanism assembly and remove the two screws G
attaching the motor.
ATTENTION: The motors can be detached before
removing the load arm.
1-8
(See Fig.9)
(See Fig.10)
(See Fig.10 and 11)
Joint h
Shaft
Fig.8
Pinch roller ass'y
Play head
Tab i
F
Tab i
Pinch roller ass'y
Fig.9
Reel disc P.W.B.
Soldering j
Tabs k
Tabs k
G
Motor
G
Fig.10
Sub motor
Tab m
Load arm
Fig.11
Cassette holder
and holder arm
Joint h
Shaft
Pinch roller ass'y
Tab i
Spring
Tab i
Cassette mechanism ass'y
Flywheel
Belt
Soldering j
Tab m
Soldering l
Tab m
Soldering l
Motor