Special Preset Commands, Pelco Protocol; About Setting The Camera Address Via Fastaddress - Bosch MIC612 Operation Manual

34 en | Getting Started
Keyboard Command User Action
91 – Aux On
92 – Aux On
7.3.5

Special Preset Commands, Pelco Protocol

Some Pelco mode preset commands have a special meaning and override the normal Pelco
preset function as follows:
Preset Command
33-PRESET
34-PRESET
80-PRESET
81-PRESET
82-PRESET
92-PRESET
93-PRESET
94-PRESET
95-PRESET
96-PRESET
97-PRESET
98-PRESET
99-PRESET
Notice!
Some Pelco controllers do not support all of the preset command numbers. Refer to the
documentation of the specific Pelco controller for supported preset commands.
7.4

About Setting the Camera Address via FastAddress

The camera offers remote addressing via the feature "FastAddress," which allows you to set or
to change a camera address using the keyboard and on-screen menus. The FastAddress
feature allows you to install all cameras first, then to set the addresses via the control system.
This feature makes it easier to re-address cameras at a later time because you do not need to
go to the physical location of the camera to change the camera's address.
2016.03 | 2.1 | F.01U.249.416
Description
Press Activate Zone Scan (display zone titles).
Press Deactivate Zone Scan (re-move zone titles)
Description
Pans the camera 180° (Flip).
Goes to Zero Pan (original home position).
Toggles the Synchronization Mode between Line Lock and Internal
(Pelco Frame Scan). This command is available if commands are
unlocked using the Main menu.
Initiates Preset Tour 1.
Initiates Preset Tour 2.
Sets the Left pan limit for an AutoScan with Limit Stops enabled.
Sets the Right pan limit for an AutoScan with Limit Stops enabled.
Initiates a Preset Tour.
Enables or disables Limit Stops in the Setup Menu for AutoScan.
Invokes the Pelco main Setup Menu when pressed for 2 seconds.
Stops a scan.
Initiates FastAddress (Pelco Random Scan).
Toggles the Synch. Mode between Line Lock and Internal (Pelco
Frame Scan). This command is available only for two (2) minutes after
the power is applied and then reverts to normal preset functionality.
Starts an AutoScan.
Operation Manual
MIC612 Thermal Camera
Bosch Security Systems