Whirlpool WRF560SEYW User Instructions page 24

PROBLEM
The water dispenser will
not operate properly
Water is leaking or dripping
from the dispenser system
NOTE: A few drops of water
after dispensing is normal.
Water continues to drip
from the dispenser beyond
the first few drops.
Water is leaking from the
back of the refrigerator
Water from the dispenser
is warm
NOTE: Water from the
dispenser is only chilled
to 50°F (10°C).
24
POSSIBLE CAUSES
The refrigerator is not connected to
a water supply or the water supply
shut-off valve is not turned on
There is a kink in the water source line
The refrigerator has just been installed
The water pressure to the house is not
at or above 30 psi (207 kPa)
A reverse osmosis water filtration
system is connected to your cold
water supply
A water filter is installed
on the refrigerator
The refrigerator door is not closed
completely (on some models)
The refrigerator doors were
recently removed
The glass was not held under the
dispenser long enough
The refrigerator has just been installed
The water filter was recently changed
The water line connections were not
fully tightened
Recently removed the doors and did
not fully tighten water line connection
The refrigerator has just been installed
A large amount of water was
recently dispensed
Water has not been recently dispensed The first glass of water may not be cool. Discard the first glass
The refrigerator is not connected
to a cold water pipe
SOLUTIONS
Connect the refrigerator to the water supply and turn the water
shut-off valve fully open.
A kink in the water line can reduce water flow from the water
dispenser and result in hollow or irregular shaped ice. Straighten
the water source line.
Flush and fill the water system. See "Water Dispenser."
The water pressure to the house determines the flow from
the dispenser. See "Water Supply Requirements."
A reverse osmosis water filtration system can decrease water
pressure. See "Water Supply Requirements."
Remove filter and operate dispenser. If water flow increases, the
water filter may be clogged or incorrectly installed. Replace filter
or reinstall it correctly.
Close the door firmly. If it does not close completely, see
"The doors will not close completely."
Make sure the water dispenser wire/tube assembly has
been properly reconnected at the top of the refrigerator
door. See "Remove and Replace Refrigerator Doors and
Drawer Front."
Hold the glass under the dispenser 2 to 3 seconds after
releasing the dispenser lever.
Flushing the water system removes the air from the lines which
causes the water dispenser to drip. Flush the water system.
See "Water Dispenser."
Flushing the water system removes the air from the lines which
causes the water dispenser to drip. Flush the water system.
See "Water Dispenser."
See "Connect the Water Supply."
See "Remove and Replace Refrigerator Doors and
Drawer Front."
Allow 24 hours after installation for the water supply
to cool completely.
Allow 3 hours for the water supply to cool completely.
of water dispensed.
Make sure the refrigerator is connected to a cold water pipe.
See "Water Supply Requirements."