What To Do If You Get Picture Interference When Using Rf Lead - Sanyo VHR-VK920A Instruction Manual

What to do if you get picture interference when using RF lead

The RF output can be adjusted from 27 to 69 (For Australia), this video is defaulted to RF36.
The RF output can be adjusted from 21 to 69 (For New Zealand), this video is defaulted to RF36.
If other broadcasts are close to RF36 they may cause picture interference, you can change
the RF output until your television has a noise-free channel for your video.
If other stations are positioned on or near the current RF OUTPUT CH, the following guide message
appears automatically.
RF OUTPUT SET
CURRENT CH 36
RECOMMENDED CH 38
OK:CONFIRM MENU:END
RF OUTPUT SET
CH 36
0-9:SET UP (27-69)
OK:CONFIRM MENU:END
For Australia
If there is still picture interference repeat option2.
Buy a RCA cable from your local electrical shop. Connect the RCA cable as shown on page
3, diagram 2.
If you want to change the RF output in the future due to new broadcasting stations or equipment and so on,
press and hold the OK button on the remote control until RF 36 is displayed on the front of the video. Then go
to option 2 above.
Option 1
IMPORTANT!
PLEASE CHANGE THE TV
CH TO 38.
Option 2
RF OUTPUT SET
CH 36
0-9:SET UP (21-69)
OK:CONFIRM MENU:END
For New Zealand
Option 3
Press OK to confirm.
Press MENU to end.
Change the RF output from 36 using the
remote control.
Press MENU. Select 'VCR Set Up' by
pressing PR- twice then OK.
Select 'RF Output Set Up' by pressing PR-
twice then OK.
Change the channel number using buttons
0-9.
Press OK to confirm. Press MENU to end.
7