Flip Mode; Low Battery Indicator; Sensor Calibration - REVELL NANO Hexagon Manual

FLIP MODE

The Nano Hexagon has a built in flip function. When the right stick is
pressed down, the TX will make a short beep to indicate it is in the flip
mode. When the right stick is moved, the Nano Hexagon will flip in the same
direction.

LOW BATTERY INDICATOR

After the Nano Hexagon has been flying for about 6 minutes, the LEDs on the arms will flash. This is a warning to land and charge the battery as
soon as possible. Always charge the battery when the flight is completed. When the LEDs are flashing, the Nano Hexagon will not have enough
power to perform a flip. Remember to ALWAYS turn off the Nano Hexagon after flight!

SENSOR CALIBRATION

If your Nano Hexagon will not hover in the same spot when the right stick is
centered, the sensors may need calibration.
1. Place the Nano Hexagon on a level surface.
2. Center the trim adjustments. The controller will make a long beep when the
trim is at the center position.
3. Change the control sensitivity to the Expert Setting (page 5). Move both
sticks to their lowest position and to right as far as possible. The LEDs on the
hex will flash for a few seconds while the sensors are being calibrated.
6
ON OFF