Troubleshooting - D-Link DAP-1150 Quick Installation Manual

TrOUbLEShOOTING

seTUP AND CONFiGUrATiON PrOBleMs
1. hOW DO I CONFIGUrE MY DAP-1155 WIrELESS N 150 ACCESS POINT WIThOUT
ThE CD, Or ChECK MY WIrELESS NETWOrK NAME (SSID) AND WIrLESS
ENCrYPTION KEY?
- connect your pc to dap-1155 using an ethernet cable.
- open a web browser and enter the address http://dlinkap
- the default username is admin. the default password is blank (leave this box empty).
- If you have changed the password and cannot remember it, you will need to reset the product
to set the password back to default.
2. hOW DO I rESET MY DAP-1155 WIrELESS N 150 ACCESS POINT TO FACTOrY
DEFAULT SETTINGS?
- ensure the product is powered on.
- press and hold the reset button on the rear of the device for 5 seconds.
Note: Resetting the product to the factory default will erase the current configuration settings.
to reconfigure your settings, log into the dap-1155 as outlined in question 1, then run the
setup Wizard.
3. hOW DO I ADD A NEW WIrELESS CLIENT Or PC IF I hAVE FOrGOTTEN MY
WIrELESS NETWOrK NAME (SSID) Or WIrELESS ENCrYPTION KEY?
- For every pc that needs to connect to the dap-1155 wirelessly, you will need to ensure you
use the correct Wireless network name (ssId) and encryption key.
- use the web based user interface (as described in question 1 above) to check or choose your
wireless settings.
- make sure you write down these settings so that you can enter them into each wirelessly
connected pc. You will find a dedicated area on the back of this document to write down this
important information for future use.
4. WhY CAN I NOT GET AN INTErNET CONNECTION?
- For cable users, make sure that the Clone MAC address option is ticked during Wizard
installation (or enter the registered mac) and that your Isp username and password is correct.
4
DAP-1155