Advertisement
When the food tank starts getting dirty and there is a lot of loose food at the
bottom of the food tank, you can remove the food cover and food tank for
cleaning.
Use a soft damp cloth to clean the feeder base which contains the control panel
and batteries. Never get this part wet and do NOT wash with running water.
You can wash the Food Cover and Food Tank in warm soapy water. DO NOT
put these parts in the dishwasher, as they will be permanently damaged!
You need to open the spring loaded locks. Use both hands
and your thumbs to push both locks down to release the
food tank. As you push the locks down, use your fingers to
lift the food tank up.
The springs are very strong, to be careful to not let the locks
snap back and hurt your fingers.
Line up the food tank with the feeder base, then press the
locks out with your thumbs so that the food tank can seat
onto the feeder base. The locks are spring loaded so be
careful not to pinch your fingers. Make sure the locks
securely lock into the food tank.
The clock can display either 12 or 24 hour format.
•
Feeding days can be changed at any time but the previous schedule will be replaced.
•
The feeding times and volumes can be changed at any time and the new settings will
•
be active for the rest of the feeding day(s) schedule.
Once the schedule has started, the DAYS displayed will reduce by one every day at
•
0:00 (midnight), until the end is reached.
If the timer-icon is OFF and all numbers are flashing, then no feeding schedule has
•
been set.
If the timer-icon is ON and all numbers are not flashing, then the schedule has
•
started.
When the CLOCK icon is ON, then the current time is displayed.
•
When the Red (LOW BATT) light flashes, the batteries are low and need replacing.
•
Change the batteries as soon as possible. You will need to reprogram all of your
settings again when the batteries are changed.
When the LCD display shows (Err), the food delivery door is not closing properly, so
•
you will need to remove any food that is jamming the door.
1.
Switch the unit OFF, remove all food, then turn the feeder upside-down.
2. Clean both doors hinges with a soft brush.
3. After cleaning, switch unit ON and refill with food.
Note: you will need to reprogram all of your original settings before you can
use your feeder again.
Always use the Quick Start Guide for fast easy programming. For more advanced
•
settings, refer to this user manual.
Food Tank Locks
5
Advertisement
