Logan Graphic Products 5000 Instruction Manual

8-ply mat cutter

Advertisement

Instruction Manual
8-Ply Bevel Cutting Instructions

Blade Installation

NOTE: Use only special 8-Ply blade #271. It has only one sharp, bev-
eled edge. DO NOT USE #270 which looks similar but has two beveled
edges. The #270 blade will not cut 8-Ply effectively (Fig. 1).
NOTE: Only one corner of blade #271 can be used (Fig. 2).
1. Loosen blade knob and remove cartridge.
2. Set blade onto blade slide, being careful of orientation of edge bevel (Fig. 3).
3. Insert blade slide into cutting head (Fig. 4).
4. Tighten blade knob.

Depth Adjustment

NOTE: Standard 8-Ply depth setting is aligning end of blade with end
of slide (Fig. 5).
1.
Set cutter onto 8-Ply mat board with blade overhanging edge.
2.
Depress blade fully.
Corner of blade tip edge should score the slip sheet past top of bevel edge (Fig. 6).
3.
4.
To adjust depth, loosen blade knob and turn depth adjustment screw.
NOTE: When reducing depth, you will have to push blade back with
your finger.
5.
Retighten blade knob.
Fig. 3
Fig. 5
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 847-526-5515 LoganGraphic.com
8-Ply Mat Cutter
CAUTION!!
MAT CUTTING BLADES ARE SHARP
Start & Stop Lines
Anti-crawl pin
Fig. 1
#271 SINGLE BEVEL 8-PLY BLADE
Front
Single Bevel
Fig. 2
Fig. 4
Fig. 6
SLIP SHEET
Model 5000

Identification

Nylon Guides

Blade Knob
Depth Knob
Back
#271 BLADE
ONLY USE THIS CORNER
8-PLY MAT
L1878N rev.2 5/14
Blade
Slide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 5000 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Logan Graphic Products 5000

  • Page 1 NOTE: When reducing depth, you will have to push blade back with your finger. ONLY USE THIS CORNER Retighten blade knob. Fig. 3 Fig. 4 Fig. 5 Fig. 6 SLIP SHEET 8-PLY MAT Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 847-526-5515 LoganGraphic.com L1878N rev.2 5/14...
  • Page 2 To improve straightness of cut, you may need to adjust the guides fit on guiderail. Hook cutter onto rail. Loosen guide screws (Fig 12). Squeeze guide against rail. Retighten guide screws. Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 847-526-5515 LoganGraphic.com L1878N rev.2 5/14...

Table of Contents