Starting Operation - Bosch GBH 24 VFR Professional Original Instructions Manual

Removing SDS-plus Drilling Tools
(see figure G)
Push back the locking sleeve 3 and remove the
tool.
Inserting Drilling Tools without SDS-plus
(GBH 24 VFR) (see figure H)
Note: Do not use drilling tools without SDS-plus
for hammer drilling! Drilling tools without SDS-
plus as well as the tool holder are damaged
when used for hammer drilling.
Insert the quick change keyless chuck 19.
Firmly hold the retaining ring of the quick
change keyless chuck 19. Open the quick
change keyless chuck by turning the front sleeve
in the direction of the symbol "
Insert the drilling tool into the quick change key-
less chuck 19. Firmly hold the retaining ring of
the quick change keyless chuck 19 and turn the
front sleeve in the direction of the symbol
"
".
Set the selector switch 6 to the "Drilling" sym-
bol.
Removing Drilling Tools without SDS-plus
(GBH 24 VFR) (see figure H)
Firmly hold the retaining ring of the quick
change keyless chuck 19. Open the quick
change keyless chuck by turning the front sleeve
in the direction of the symbol "
Remove the drilling tool.
Inserting Drilling Tools without SDS-plus
(GBH 24 VRE)
Note: Do not use drilling tools without SDS-plus
for hammer drilling! Drilling tools without SDS-
plus as well as the tool holder are damaged
when used for hammer drilling.
Insert the key type drill chuck 17.
Open the key type drill chuck 17 by turning until
the tool can be inserted. Insert the tool.
Insert the chuck key
holes of the key type drill chuck 17 and clamp
the tool uniformly.
Set the selector switch 6 to the "Drilling" sym-
bol.
Bosch Power Tools
".
".
into the corresponding
Removing Drilling Tools without SDS-plus
(GBH 24 VRE)
Turn the sleeve of the key type drill chuck 17
with the drill chuck key in anticlockwise direc-
tion until the drilling tool can be removed.
Operation

Starting Operation

Inserting the Battery
Use only original Bosch O-pack batteries
with the voltage given on the type plate of
your machine. The use of other batteries can
lead to injuries and danger of fire.
Before inserting the battery, remove the protec-
tion cap 15, if required. (see figure B)
Set the rotational direction switch 7 to the cen-
tre position in order to avoid unintentional start-
ing. Insert the charged battery 11 into the han-
dle so that it can be felt to engage and faces
flush against the handle.
Setting the Operating Mode
Actuate the selector switch for drill-
ing/hammer drilling 6 only when the power
tool is at a standstill.
Hammer drilling
Set the selector switch 6 to the
"Hammer drilling" symbols.
Drilling
Set the selector switch 6 to the
"Drilling" symbol.
English | 23
1 619 929 740 | (24.7.07)