Nand Flash Memory - Mx25L1005 (U158); General Description; Features; Absolute Maximum Ratings - Sharp LC-19LE510E Service Manual

14. 13.1

NAND FLASH MEMORY - MX25L1005 (U158)

13.
14.1.

General Description

MX25L1005 is a CMOS 1,048,576 bit serial Flash memory, which is configured as 131,072 x 8 internally.
The MX25L1005 feature a serial peripheral interface and software protocol allowing operation on a simple
3-wire bus. The three bus signals are a clock input (SCLK), a serial data input (SI), and a serial data output
(SO). SPI access to the device is enabled by CS# input. The MX25L1005 provide sequential read operation
on whole chip. After program/erase command is issued, auto program/ erase algorithms which program/
erase and verify the specified page or sector/block locations will be executed. Program command is
executed on page (256 bytes) basis, and erase command is executes on chip or sector(4K-bytes) or
block(64K-bytes). To provide user with ease of interface, a status register is included to indicate the status
of the chip. The status read command can be issued to detect completion status of a program or erase
operation via WIP bit. When the device is not in operation and CS# is high, it is put in standby mode and
draws less than 10uA DC current. The MX25L1005 utilize MXIC's proprietary memory cell, which reliably
13.2
stores memory contents even after 100,000 program and erase cycles.
14.2.

Features


Serial Peripheral Interface (SPI) compatible -- Mode 0 and Mode 3

1,048,576 x 1 bit structure

32 Equal Sectors with 4K byte each, Any Sector can be erased individually

2 Equal Blocks with 64K byte each, Any Block can be erased individually

Single Power Supply Operation

2.7 to 3.6 volt for read, erase, and program operations

Latch-up protected to 100mA from -1V to Vcc +1V
13.3

Low Vcc write inhibit is from 1.5V to 2.5V
14.3.

Absolute Maximum Ratings

RATING
Ambient Operating Temperature
Storage Temperature
Applied Input Voltage
Applied Output Voltage
13.4
VCC to Ground Potential
14.4.

Pinning

8-PIN SOP (150mil)
SYMBOL
CS#
14.4. Pinning
8-PIN SOP (150mil)
SYMBOL
CS#
SI
SO
SCLK
HOLD#
VCC
GND
DESCRIPTION
55
Chip select
VALUE
0°C to 70°C
-55°C to 125°C
-0.5v to 4.6v
-0.5v to 4.6v
-0.5v to 4.6v
DESCRIPTION
Chip select
Serial Data Input
Serial Data Output
Clock Input
Hold, to pause the device without
deselecting the device
+3.3v Power Supply
Ground
LC-19LE510
LC-22LE510
LC-24LE510