http://www.xiaoyu163.com SPECIFICATIONS K MODEL 3 7 63 1515 0 LH, HA MODELS • • Design and specifications are subject to change without Design and specifications are subject to change without notice notice EZ MODEL L 13942296513 • Design and specifications are subject to change without notice u163 http://www.xiaoyu163.com...
http://www.xiaoyu163.com PROTECTION OF EYES FROM LASER BEAM DURING SERVICING This set employs laser. Therefore, be sure to follow carefully the CAUTION 3 7 63 1515 0 instructions below when servicing. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous WARNING! radiation exposure.
Page 7
http://www.xiaoyu163.com IC BLOCK DIAGRAM IC, LA1828 IC, LA6541D 3 7 6 3 1 5 1 5 0 • Regarding connectors, they are not stocked as they are not the initial order items. The connectors are available after they are supplied from connector manufacturers upon the order is received. CHIP RESISTOR PART CODE Chip Resistor Part Coding Figure...
Page 8
http://www.xiaoyu163.com WIRING-1 (MAIN/CD) 3 7 6 3 1 5 1 5 0 1 3 9 4 2 2 9 6 5 1 3 w w w u 1 6 3 http://www.xiaoyu163.com...
Page 9
http://www.xiaoyu163.com SCHEMATIC DIAGRAM-1 (MAIN) 3 7 6 3 1 5 1 5 0 MTZJ6.8B MTZJ6.8B 1 3 9 4 2 2 9 6 5 1 3 LH MODEL AC JACK K, EZ MODELS 100 1SS133 w w w u 1 6 3 PT, H 2.5W PT, E 2.5W PT, E 2.5W...
Page 10
http://www.xiaoyu163.com SCHEMATIC DIAGRAM-2 (CD) 3 7 6 3 1 5 1 5 0 1 3 9 4 2 2 9 6 5 1 3 w w w u 1 6 3 http://www.xiaoyu163.com...
Page 11
http://www.xiaoyu163.com WIRING-2 (MOTOR) TRANSISTOR ILLUSTRATION 3 7 6 3 1 5 1 5 0 E C B E C B E C B 2SA1296 2SA933 2SA1318 2SC1815 2SC1740 H MOTOR C.B DTC114TS DTC124XS (SLED MOTOR) 2SC2714 2SB1370 DTC114TK (INSIDE LIMIT SW) DTC114YK DTC144TK (SPINDLE MOTOR)
Page 12
http://www.xiaoyu163.com WIRING-3 (FRONT/HP/BATT1/BATT2/KEY) 3 7 6 3 1 5 1 5 0 F BATT1 C.B G BATT2 C.B LH MODEL E H.P. C.B (INSERTED PARTS) (INSERTED PARTS) J VOL SEL C.B (INSERTED PARTS) (INSERTED PARTS) SPEAKER SW901 AC VOLTAGE 110-120V 220-240V SW901 PT901...
http://www.xiaoyu163.com PRACTICAL SERVICE FIGURE < TUNER SECTION > 3 7 63 1515 0 < FM SECTION > Sensitivity: Less than 19dB (88.0MHz) (THD 3%) Less than 18dB (98.0MHz) Less than 18dB (108.0MHz) Signal to Noise Ratio: LH MODEL: (Input 60dB) More than 57dB (at 98.0MHz) K, EZ MODELS: More than 50dB (at 98.0MHz)
Page 20
http://www.xiaoyu163.com IC DESCRIPTION IC, LA9241ML 3 7 63 1515 0 Pin No. Pin Name Description Pin to which external pickup photo diode is connected. RF signal is created by adding FIN2 with the FIN1 pin signal. FE signal is created by subtracting from the FIN1 pin signal. FIN1 Pin to which external pickup photo diode is connected.
Page 21
http://www.xiaoyu163.com 3 7 63 1515 0 Pin No. Pin Name Description Pin from which TES signal is output to DSP. “High Frequency Level” is used to judge whether the main beam position is on top of bit or on top of mirror. SLOF Sled servo off control input pin.
Page 22
http://www.xiaoyu163.com IC, LC78622ED 3 7 63 1515 0 Pin No. Pin Name Description DEFI Defect sense signal (DEF) input pin. (Connect to 0V when not used). Test signal input pin with built-in pull-down resistor. Be sure to connect to 0V. Phase comparator output pin to control external VCO.
Page 23
http://www.xiaoyu163.com 3 7 63 1515 0 Pin No. Pin Name Description XVDD — Crystal oscillator power supply pin. XOUT Pin to which external 16.9344 MHz crystal oscillator is connected. XVSS — Crystal oscillator GND pin. Be sure to connect to 0V. SBSY Subcode block sync signal output pin.
Page 24
http://www.xiaoyu163.com IC, LC865516A-5K51 3 7 63 1515 0 Pin No. Pin Name Description SEG E SEG E control. SEG F SEG F control. SEG G SEG G control. — Not connected. ______________ RESET Micro processor reset input XT1 (IN) Connected to an external 32.768 kHz crystal oscillator. —...
Page 25
http://www.xiaoyu163.com 3 7 63 1515 0 Pin No. Pin Name Description — Not connected. SEG DP SEG DP control. SEG A SEG A control. SEG B SEG B control. SEG C SEG C control. SEG D SEG D control. — Not connected.