Table of Contents
Advertisement
Operation
Switching on the appliance
WARNING: Check with your floor manufacturer to see whether your floor type is suited to being cleaned
with an electric brush sweeper.
1. Place the appliance down on the floor.
2. Pull the tube towards you, thereby bending down the brush base. The brush base should now be on the floor
however you hold the tube.
Adjusting the sweeping performance
I
II
Switching off
vax.com.au
505
vax.co.nz
900
3. Switch on the brush sweeper by moving the slider switch
to the 'I' position - The brush rollers rotate at the medium speed.
NOTE: This should be sufficient for sweeping hard floors. To sweep
short-pile carpets, push the slider switch further down to position 'II'.
The appliance is designed to sweep shortpile carpets alone (e.g. carpet pile
no longer than 5 mm). The appliance does not work on longer carpet piles.
When the appliance is running you can switch between switch settings
'I' and 'II' as required.
NOTE: We recommend using the medium setting (I) so that you can use
a battery charge for as long as possible (the (II) setting draws more power
from the battery).
NOTE: If the battery power has reduced markedly or the brushes will no
longer rotate, the battery pack has to be charged (refer to "Charging the
battery pack", page 7).
Put the slide switch to position '0'.
Move the tube until it is at right angles with the brush base and clicks into
place and the appliance can stand on its own.
Empty the dust container if required (refer to "Emptying the dust container",
page 9).
8
Advertisement
Table of Contents
