MTX TSW10 Owner's Manual page 8

B) For use with A/V preamps and receivers that have a subwoofer line level output.
If your preamplifier or receiver has a dual "subwoofer" output or "LFE" output, connect a shielded
RCA cable from the preamplifier output to both the left and right low level inputs on the subwoofer. If
the amplifier has a single "subwoofer" output or "LFE" output, connect a shielded RCA cable from the
preamplifier output to either one of the subwoofer line level inputs. Refer to Figure E.
8
High Level
L R
In Out In Out
On
Low Input
L
R
0°
Power
Powered Subwoofer
Volume
ATTENTION / CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING: To reduce the risk of fire
Min Max 60Hz
or electrical shock, do not expose this
appliance to rain or moisture.
~115V - 230V 60Hz / 50Hz
High Level
L R
In Out In Out
On
Low Input
L
R
0°
Power
Powered Subwoofer
Volume
ATTENTION / CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING: To reduce the risk of fire
Min Max 60Hz
or electrical shock, do not expose this
appliance to rain or moisture.
~115V - 230V 60Hz / 50Hz
Amp Output (Low Level)
Auto
Off
Phase
180°
Crossover
180Hz
AC Voltage Selector
On
Off
Caution:
To reduce the risk
of fire, replace with
only the same type
and rating fuse.
Fuse Type
T3AL / 250V
150 Watts
Auto
Off
Phase
180°
Crossover
180Hz
AC Voltage Selector
On
Off
Caution:
To reduce the risk
of fire, replace with
only the same type
and rating fuse.
Fuse Type
T3AL / 250V
150 Watts
M T X . C O M
Amplifiers