User Instructions; Combustible Materials; Air Controls - Henley Hampton 21kW Installation And Operating Instructions Manual

User Instructions

The Clean Air Act 1993 and Smoke Control Areas
Under the Clean Air Act local authorities may declare the whole or part of the district of the authority to be a smoke control area. It is an
offence to emit smoke from a chimney of a building, from a furnace or from any fixed boiler if located in a designated smoke control area.
It is also an offence to acquire an "unauthorised fuel" for use within a smoke control area unless it is used in an "exempt" appliance ("ex-
empted" from the controls which generally apply in the smoke control area).
The Secretary of State for Environment, Food and Rural Affairs has powers under the Act to authorise smokeless fuels or exempt appliances
for use in smoke control areas in England. In Scotland and Wales this power rests with Ministers in the devolved administrations for those
countries. Separate legislation, the Clean Air (Northern Ireland) Order 1981, applies in Northern Ireland. Therefore it is a requirement that
fuels burnt or obtained for use in smoke control areas have been "authorised" in Regulations and that appliances used to burn solid fuel in
those areas (other than "authorised" fuels) have been exempted by an Order made and signed by the Secretary of State or Minister in the
devolved administrations.
The Thames has been recommended as suitable for use in smoke control areas when burning wood/ancit.
Further information on the requirements of the Clean Air Act can be found here : http://smokecontrol.defra.gov.uk/
Your local authority is responsible for implementing the Clean Air Act 1993 including designation and supervision of smoke control areas
and you can contact them for details of Clean Air Act requirements

Combustible Materials

Safe distances to combustible materials should be 800mm to the rear and 700mm to the side. Ideally, adjacent walls should be of suit-
able non combustible construction, preferably brickwork. In large fireplaces take care that any supporting beam is protected by a 13mm
(0.5") thick sheet of Masterboard / Supalux spaced 13mm (0.5") off the surface with strips of non-combustible material.
Make sure that there is a gap between an un-insulated flue system and any combustible material. This gap must be at least 3x the out-
side diameter of the flue pipe, or 1.5x the flue diameter to non-combustible surfaces.

Air Controls

Henley Stoves appliances have air systems providing
cleaner burning, and greater efficiency and control,
please see the diagram to view where the various air
controls are located on your Henley Stove.
1) Primary Air - Turning this wheel anti-clockwise opens
the primary air and allows air into the stove. You would
normally open this wheel when starting a fire to allow air
into the stove for maximum combustion.
2) Secondary Air (Airwash)- The secondary air allows a
film of air to pass over the glass which in turn keeps the
glass clean. Please note the glass may become visibily
darker when the stove is cold.
3) Tertiary Air - Tertiary air further compliments the
cleanburn system as a third air intake. The air is drawn
up the back of the stove via a series of chambers and is
then injected into the back of the upper fire chamber
through small steel jets. The jets of superhot air ignite the
remainder of gases that will only burn off at very high
temperatures.
Pull out to
open the primary air
8 | www.henleystoves.com
Door Handles
Thermostat
External Air Intake
Push in to
close the primary air
Stove Door
Riddle Bar
Stove Legs
DO NOT USE YOUR BARE
HAND TO ADJUST AIR
CONTROLS WHILE THE
STOVE IS IN USE, USE A
PROTECTIVE GLOVE