Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for getAir LED control
- Page 1 LED Control Installation and operating instructions V 1.1...
-
Page 3: Table Of Contents
Table of contents 1. General remarks ..................4 1.1 Safety information ........................4 2. Installation preparations ..............5 2.1 Contents ............................5 2.2 Component sizes ........................5 3. Installation ....................6 3.1 Electrical installation ........................6 3.2 Mechanical installation ......................8 4. Operating the system ................9 4.1 Control screens ........................... -
Page 4: General Remarks
1. General remarks This document contains the installation and operating instructions for the LED Control. It is to be handed over to the end user (tenant, owner, building management, etc.) once the installation has been completed. This document is part of the system and must be kept readily available. -
Page 5: Installation Preparations
Before starting installation, please check whether all components are present, as other- wise it will not be possible to complete the installation. Article name Item Content Quantity 1 LED screen 2 Control element LED Control 3 Frame 4 Power supply 2.2 Component sizes Name Width Height Depth Ø... -
Page 6: Installation
All electrical work must be performed by a qualified electrician. Make sure that all wiring is done correctly. +12V (4) Bus B (3) Bus A (2) GND (1) Control element schwarz Power supply LED Control - Installation and operating instructions... - Page 7 Control Control Control The LED Control can be placed at an arbitrary place within the BUS-network. It is possible to run the cables in row, ring-shaped or also radial. LED Control Installation and operating instructions -...
-
Page 8: Mechanical Installation
SmartFan fan units are equipped with a DIP switch on the top. The fan unit has to be set to group 1 and a starting direction has to be chosen, if you are using the LED Control. 3.2 Mechanical installation Install the control unit at standard wall height. -
Page 9: Operating The System
The system runs in just one direction, allowing a room to be thoroughly ventilated. Heat recovery is not available in this mode. In the main menu the SmartFan‘s starting direction can be reversed through touching the Full-Blast -Mode icon. LED Control Installation and operating instructions -... -
Page 10: Further Functions
In doing so, the internal meter is also reset. the oPtimum time to rePlace the filter may Vary through the Present enVironmental conditions. LED Control - Installation and operating instructions... -
Page 11: Technical Data
Packaging should be sorted before disposal. Electronic devices or batteries do not belong in normal household refuse. Should you want to dispose of your ventilation unit, please do so in accordance with current national regulations. Contact the appropriate authority. LED Control Installation and operating instructions -... -
Page 12: Warranty
7. Warranty getAir GmbH & Co. KG provides a 2-year warranty on the control unit. The warranty will expire in the following cases: • Damage caused by the incorrect / improper handling and use or through non- compliance with the installation and operating instructions. -
Page 13: Notes
8. Notes LED Control Installation and operating instructions -... - Page 15 E-Mail: info@getair.eu Website: www.getair.eu Picture credits: © getAir GmbH & Co. KG 2015 All rights reserved: © getAir GmbH & Co. KG 2015 Subject to change. No liability is assumed for the information contained herein. The partial or complete reproduction (prints,...
Need help?
Do you have a question about the LED control and is the answer not in the manual?
Questions and answers