Wheels And Axle - MTD remington Shop Manual

Wheels and Axle

To remove the wheels and axle:
1. Remove the screw and washer that secures the
wheel, using a 7/16" wrench. See Figure 19.
NOTE: If the axle is being removed, the left wheel
must be removed.
NOTE: Both wheels are supported with an inner
and outer sealed ball bearing
NOTE: There is a stop welded to the axle where it
passes through the right hand side of the
trimmer base. This stop will not allow the
axle to slide or rotate. See Figure 20.
12
axle bolt
and
washer
Figure 19
Figure 20
Axle stop and
hole in frame