Rear Panel - NETGEAR Nighthawk X4S R7800 User Manual

LED
Ethernet ports 1–4
WiFi On/Off button with
LED
WPS button with LED
You can use the LED On/Off switch on the rear panel of the router to turn the LEDs on the top of the router on or
off. See Turn the LEDs On or Off

Rear Panel

The rear panel connections and buttons are shown in the following figure.
Figure 3. Router rear panel
Pressing the Reset button restores the factory settings. See
Nighthawk X4S AC2600 Smart WiFi Router
Description
The LED color indicates the speed: white for Gigabit Ethernet connections and amber for 100 Mbps or
10 Mbps Ethernet connections.
• Solid. A powered-on device is connected to the Ethernet port.
• Blinking. The port is sending or receiving traffic.
• Off. No device is connected to this Ethernet port.
Pressing this button for two seconds turns the 2.4 GHz and 5 GHz WiFi radios on and off.
If this LED is lit, the WiFi radios are on. If this LED is off, the WiFi radios are turned off and you cannot
use WiFi to connect to the router.
This button lets you use WPS to join the WiFi network without typing the WiFi password. The WPS LED
blinks white during this process and then lights solid white.
on page 12.
Hardware Setup
Factory Settings
11
on page 158>