Switching Off; Changing The Dust Bag - Morphy Richards Goblin 73276 Instructions Manual

Bagged cylinder vacuum cleaner
Table of Contents

Advertisement

73276 rev1
30/9/08
G
H
I
J
K
L
M
U U K K H H e e l l p p l l i i n n e e 0 0 8 8 4 4 4 4 8 8 7 7 1 1 0 0 9 9 4 4 9 9
6
13:22
Page 6
Tube standby
During short breaks in cleaning,
the tubes can be held in an
upright, 'standby' position ‰,
whilst you move furniture for
instance.
IMPORTANT: Ensure that the
appliance is never left
unattended whilst it is switched
on.

Switching off

Switch off the appliance.
Remove the plug from the mains
supply and rewind the power
cable using the cable rewind
switch ·.
WARNING: When using the
cable rewind, always hold
the plug as the cable will
rewind quickly.
STORAGE
Tube park
I
The vacuum cleaner can be
stored in an upright position.
Rotate the floor nozzle until the
lug on the neck can be fitted
into the tube park slot Ê on the
base of the appliance.
MAINTENANCE
DUSTBAG
Changing the
dustbag
If suction power is reduced or if
the 'dustbag full' indicator ‡ is
permanently fully red, the
dustbag needs changing. Also,
check whether the suction hose,
tube or nozzle are blocked.
To access the dustbag, press
the dust compartment release
lever ¤ to open the cover J.
R R e e p p l l a a c c e e m m e e n n t t P P a a r r t t s s 0 0 8 8 4 4 4 4 8 8 7 7 3 3 0 0 7 7 1 1 5 5
G
1
Pull the tab on the dustbag to
one side so that the opening is
hygienically sealed.
2
Pull out the dustbag holder È
and dustbag in an upward
direction K.
3
Pull the bag Ë sideways out of
the holder È L.
4
Dispose of the bag with your
household waste.
5
Insert a new dustbag in the
H
holder.
6
Replace the dustbag holder and
close the cover.
IMPORTANT: If a dustbag is not
fitted, the cover will not close.
This is a safety feature.
FILTERS
Changing/cleaning
the motor protection
filter
The motor protection filter is
accessible from the dust
compartment only when the
dustbag has been removed first.
IMPORTANT: Never use the
appliance without the motor
protection filter installed,
otherwise damage to the motor
may occur which would not be
covered by the guarantee.
Slide the filter cover ‹ upwards
1
to remove M.
2
Take out the filter and clean (by
shaking) or wash M.
3
To wash the filter, gently wash in
warm water and leave to air dry.
Do not use detergents. Ensure
the filter is fully dry before
replacing into the machine.
4
Slide the filter holder back into
position.
IMPORTANT: Check this filter
every time the dustbag is
replaced and clean if necessary.
I I r r e e l l a a n n d d H H e e l l p p l l i i n n e e 1 1 8 8 0 0 0 0 4 4 0 0 9 9 1 1 1 1 9 9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bagged cylinder vacuum cleaner - rev 1

Table of Contents