Advertisement
4- Take some water out of the groups in order to release possible air inside the
system. Also, the electronic level indicator (placed between the 2 touch pads) will
indicate at any time if the boiler has or not the necessary level of water, and the
pump and the solenoid will automatically work each time the boiler needs water.
5- When the water inside the boiler is hot (it usually takes 15-20 minutes) the Red
Led of the heating element turns Off, and the pressure showed on the gauge is
around 1Bar. Now the pressure-stat runs the machine, so the heating element will
work only when the pressure goes under 1Bar.
6- Check that the pressure showed on the gauge is Ok. Net pressure should be
around 5 Bar and pump pressure when making coffee around 9Bar.
7- Pump and boiler pressures can be easily adjusted by touching the wheel of the by-
pass in the pump and the screw on the top of the pressure-stat respectively.
8- Now the machine is ready to make coffee and give hot water and steam.
Note: If your machine comes with high groups to prepare high cups, use the stand
for cups integrated on the machine to prepare large cups of coffee.
3- PLAYING WITH THE MACHINE
When all seems ready to work, we recommend playing with the machine. It means taking
water from the group by pushing on the touchpad buttons (3), and getting steam and hot
water. Like this, the group and wands will keep hot and ready to make coffee.
It is a good habit to check once on a while the pressure of the machine, and make sure that
everything works properly: safety valve, pump, Leds, steam and water wands, etc.
When finishing, please clean the machine with a wet cloth, and make sure the filter and
filter-holder are properly cleaned. To make sure the group is clean we recommend pouring
some water using the touchpad.
4- PROGRAMMING THE MACHINE
This machine comes only in Automatic version, so use the touchpad to program the quantity
of water for each button of the pad. If you want to modify the coffee volume served for each
dose, please proceed this way:
1- Press the continuous (*) button and keep it pressed 5 seconds until the Led blinks.
2- Press the dose button that you want to program, and let the water pouring.
3- When the volume is what you want the dose to be, press the dose button again
and it will keep automatically programmed.
4- Repeat step Num 3 to modify the other dose buttons. (We recommend following
this process with the filter holder filled with coffee, to ensure that the final quantity
is what you desire to cup to be).
5- Left touch pad is the master, so if you program the left side, same quantities will
keep programmed on the right side.
5- ALARM
The touch pads of the machine blink if machine can't fill the boiler within 120 seconds. Also,
the touch pads blink if the brewing is too slow...
...so, MAKE SURE THE ALARM IS QUITE, AND ENJOY YOUR MACHINE!
Advertisement
