Advertisement
AAssembly for Metal Frame Pools
Note: if you are using INFLATABLE POOL WITH TOP RING, GO TO PAGE 4
Step 1:
(1) Unlock the Hanger Lock from the Trap Body (P01)
as indicated.
(2) Insert and lock the Frame Hanger (P08) to the Trap
Body (P01) at desired position.
Step 2:
(1) Connect one end of the Skimmer Hose (P11) to the
bottom of the Trap Body (P01).
(2) Connect the other end of the Skimmer Hose (P11)
to the Hose Adaptor (P04) as shown.
Step 3:
(1) Place the assembled unit over the top of a FRAME
Pool Top Beam near the water outlet (that is, the lower
hose connection to the filter pump's inlet).
(2) Adjust the Frame Hanger (P08) by fastening the
Screw Set (P09 Plastic Ladder + P10 Screw) to be
tight on the top beam. Make sure the Frame Hanger
(P08) is securely tightened over the pool.
Step 4:
Secure the Skimmer Hose (P11+P04) properly to the
water outlet and adjust the height of the Trap Body
(P01) to a 2 cm lower than the water level.
6
2013
7
www.jilong.com
PSS-14-GB
Step 5:
Place the Skimmer Strainer (P06), which has already
assembled with Skimmer Top (P07), into the Trap
Body (P01). Gently push downwards and immerse the
Skimmer Strainer (P06) until it is well in place.
Note:
Ensure the Skimmer Top (P07)) is floating parallel
against the water surface at all time and should be
floating perpendicularly off the Trap Body (P01). Adjust
the surface skimmer position if necessary.
Step 6:
Lastly, refer to the filter pump system picture as
shown. You can now start setting up the Filter Pump
by following the owner's manual.
Step 7:
Connect the filter pump to an electrical outlet and it is
set to work. Enjoy !
www.jilong.com
PSS-14-GB
Advertisement
